[1] YIN L M,LIU D H.Study of hot mill rolls by surfacing strengthen[J].Welding Technology,2004,33(2):21-22(in Chinese).
[2] XU J Y,SONG Y M,GAO Y,et al.Investigation on microstructure and property of low-carbon steel surface strengthened layer[J].Acta Armamentarii,2006,27(6):1068-1071(in Chinese).
[3] LÜ J M,WU Zh D.Laser surface strengthening of hot-rolling blooming rolls[J].Laser & Optoelectronics Progress,2003(2):56-57(in Chinese).
[4] TANG J M,QIAO Sh R.Study on wear resistance of 40Cr steel strengthened layer by electrical discharge[J].Hot Working Technology,2006,35(22):52-55(in Chinese).
[5] WANG Zh T,YANG M J.The experimental study of delay time discharge in laser guiding discharge machine[J].Laser Journal,2002,23(2):29-32(in Chinese).
[6] LI Zh Y,YANG M J.Investigation on crater morphology by laser-induced discharge texturing[J].Applied Laser,2004,24(1):9-12(in Chinese).
[7] ZHAN J,YANG M J.Investigation on crater morphology by laser-induced discharge texturing[J].Applied Laser,2007,27(2):85-87(in Chinese).
[8] TZORTZAKIS S,PRADE B,FRANCO M,et al.Femtosecond laser-guided electric discharge in air[J].Phys Rev,2001,64(057401):1-4.
[9] VIDAL F,COMTOIS D,CHIEN Ch Y,et al.Modeling the triggering of streamers in air by ultrashort laser pulses[J].IEEE Trans Plasma sci,2000,28(2):418-432.
[10] YAMAURA M,WATANABE T,HAYASHI N,et al.Effect of triggered discharge using an excimer laser with high-repetition-rate of the order of kilohertz[J].A P L,2005,86(13):131502/1-131502/3.
[11] WANG Zh T.Study on the mechanism of laser-guided discharge and complex texturing[D].Beijing:Institute of Mechanics,Chinese Academy of Sciences,2002:57-69(in Chinese).