[1] DING L X,WANG Y M.Wear resistant coating and performance of titaruum & titanium alloy[M].Shenyang:Northeastem University Press,2006:1(in Chinese).
[2] WANG H M.Research progresa on laser surface modificationa of metallic materials and laaer rapid forming of high perfonnance metallic components[J].Acta Aeronautic et Astronautic Sinica,2002,23(5):473-478(in Clunese).
[3] WANG H M,ZHANG L Y,LI A,et al.Rapid solidification laser processing and forming of advanced aeronautical metallic materials[J].Journal of Beijing University of Aeronautica and Astronautics,2004,30(10):962-967(in Chinese).
[4] WANG H M,ZHANG L Y,LI A,et al.Progresa on rapid aoLidification laser processing for advanced materials and components[J].Wodd Sci-Tech R&D,2004,26(3):27-31(in Clunese).
[5] XUE Y,WANG H M.Microstructure and wear properties of laser clad TiCo/Ti2 Co intermetallic coatings on titanium alloy[J].Applied Surface Science,2005,243(1):278-286.
[6] HOFMANN H,FROMMEYER G,DERDER C.Creep mecluuusms in particle strengthened a-titanium-Ti2 Co alloys[J].Materials Science and Engineering,1998,A245(2):127-134.
[7] HOFMANN H,FROMMEYER G,HERZOG W.Dislocation-creepcontrolled super plasticity at high strain ratea in the ultntfine-grained quasi-eutectoid Ti-10Co-4Al alloy[J].Materials Science and Engineering,1995,A203(1/2):128-133.
[8] XUE Y,WANG H M.Microstructure and wear resistance of laser melted Ti5 So3:TiCo-Ti2 Co multiphaae intermetallic alloy[J].Rare Metal Materials and Engineering,2007,36(9):1623-1627(in Chineae).
[9] WANG F,MEl J,JIANG H,et al.Laser fabrication of T16A14V/T1C compoaitea using simultaneous powder and wire feed[J].Materials Science and Engineering,2007,A445/446(1/2):461-466.
[10] LIU D,ZHANG S Q,LI A,et al.Microstructure and tensile prop erties of laaer melting deposited TiC/TA15 titanium matrix compoaite[J].Jourual of Alloya and Compounds,2009,485(1/2):156-162.
[11] WU W L,YANG D E zh,SUN R L.Microstructure of laser clad Ti+TiC powders on T16A14V alloy substrate[J].Laser Technology,2003,27(4):307-310(in Chinesc).
[12] ZHANG S,ZHANG Ch H,WU W T,et al.An in situ formed TiC particle reinforcement composite coating induced by lases melting on surface of alloy Ti6A14V and its wearing performance[J].Acta Metallurgica Sinica,2001,37(3):315-320(in Chineae).
[13] WANG W F,WANG M C,SUN F J.Morphological charscteristics and growth mechanism of in situ TiC in titanium-based coating formed by laaer cladding[J].Heat Treatment of Metals,2009,34(2):65-69(in Chinese).